Guard, aluminum dust spout & hand brake are standard equipment

Northfield Production Shapers are constructed with rugged iron castings and balanced rotating components to assure vibration free performance. Spindles are available to 1-1/2" diameter and up to 8" in length. TEFC motors to 15 hp can be provided.

Extras

K-50 fence with hold down springs

Micrometer adjust for K-50 fence

3/4, 7/8, 1-1/8, 1-1/4, 1-3/8, 1-1/2 solid spindles

6-1/2" spindle length 1, 1-1/8, 1-1/4 solid spindle only

8" spindle length 1-3/8, & 1-1/2 solid spindle

Reversing solid spindle with reversing switch

Detachable non-reversing spindle screw-on type 3/4, 7/8, 1, 1-1/8, 1-1/4"

Detachable reversing spindle taper type 3/4, 7/8, 1, 1-1/8"

Detachable router top 1/2" hole

Collet spindle (3/4" max collet bore)

6000 & 4000 RPM spindle speed

NEMA 12 electrics with fused disconnect

24-volt push-button

6" front & rear table extensions

Switch to disconnect power upon actuation of brake

Clockwise spindle rotation

Miter gauge with dovetail slot

Single phase 3, 5, 7-1/2" hp, 220-volt

Throat hole and plates available: 8", 6-1/2" and nested

42" x 42" table

Digital read-out spindle position