Craftsman 10 Contractor Saw which features a solid cast iron table with stamped steel extensions give you a large 40 by27 inch work surface. The 1 3/4HP motor can operate at 120 or 240 volts (prewired for 120VAC, 15 amps). Features a 10-in. inch left tilting blade, aluminum fence with front/rear lock, 4-inch dust port, and mobility kit.

Kit Includes:

10 blade

Blade guard

Dust chute

Extension rails

Miter gauge

Rip fence

1-3/4 hp, 3450 RPM motor

Features:

Heavy-duty, cast-iron table with stamp steel extension and sturdy stamp steel stand

Electric

10 left tilt arbor

T-square fence with front and rear lock

Weight: 265 lbs.

Some assembly required

The dual locking fence can be easily be adjusted to be parallel to the miter slot and perpendicular to the table.

The blade guard system with anti-kickback pawls is designed with a quick release mechanism for easy removal and replacement.

Riving knife system used on this saw can be set at 3 different positions:1. Through cuts such as ripping or crosscutting (Riving knife positioned above the blade)2. Non-Through cuts with the standard 10 inch blade, such as rabbet joints (Riving knife positioned just below the top of the blade)3. Dado Cuts with 6 inch or 8 inch dado blades: where the riving knife is positioned below the table surface

The blade tilts to the left from 0 to 45 degrees to permit cutting long bevel rips on wide boards with the finish work surface in the correct position.

The blade is supported by a cast iron trunion system for accuracy and consistent cutting performance for the long term.

The heavy-duty dual castor system can be easily set with the front and rear foot pedals.

The saw includes storage for all of the accessories:1. Rip Fence2. Miter Gauge3. Blade and blade changing wrench4. Blade Guard System with anti-kickback pawls5. Push Stick