This is the "big daddy" in our line of extreme-duty planers! This machine has all the features of its little brother, like the power up/down control for the table and a variable speed feed.

The bed rollers on this machine are also power driven and adjustable for height when rough-cut lumber is milled. Segmented chip breaker, four knife cutterhead or optional spiral cutterhead and a feed rate of 20-40 feet per minute means you can get the best possible finish. Check out the specs and features below, this machine will hold up to the most strenuous production runs.

• Precision-ground cast iron table
• Power feed rollers are steel, segmented infeed and polished outfeed
• Cutterhead is one piece machine shaft with 4 knife slots and shielded ball bearings
• Micro adjustment of table height
• Segmented chip breaker
• Variable feed rate
• 5" dust port
• Convenient control panel